Basement & Bathroom Plumbing in Pocatello, ID

Fixture repairs

A toilet that keeps refilling usually has a worn flapper or a fill valve set too high. A dripping faucet usually needs a new cartridge or washer. Old shut-off valves under sinks often seize or weep, so replacing them during a repair saves trouble later.

Finishing a basement

Before the walls go up, have a plumber look at every pipe that will be hidden. Move anything that's on a cold exterior wall to the warm side of the insulation, add access panels for shut-offs and cleanouts, and make sure the floor drain will still be reachable.

Adding a basement bathroom

A new bathroom below the main sewer line may need an ejector pump, while one above it can drain by gravity. The plumber can check the depth of your line, the location of the stack and how the new fixtures will be vented.

Updating older bathrooms

Homes from the early and middle 1900s may have galvanized supply pipe that rusts inside and cuts pressure. If the walls are open for a remodel, replacing it then is far cheaper than doing it later. Ask what the plumber finds.

Permits

Larger plumbing changes usually need a permit and inspection in Idaho. Licensed plumbers normally arrange it. Our Idaho license guide explains how to check who you're hiring.

Getting a quote

Describe the project, the age of the house and anything you've noticed. Send a request and a plumber will get in touch.

Access panels

Before tiling or finishing a wall, ask for access panels behind shower valves and at any cleanout or shut-off. A small panel saves cutting into a finished wall later, when a valve needs a new cartridge or a drain needs clearing.