Well Pump & Pressure Tank Service near Pocatello, ID

How it works

The pump pushes water from the well into a pressure tank, which holds it under air pressure. A pressure switch turns the pump on when pressure drops to a set point and off when it reaches the top. When all three work, you never think about them.

Short cycling

If the pump clicks on and off every few seconds while a tap runs, the pressure tank has probably lost its air charge or the bladder inside has failed. That puts heavy wear on the pump motor, so it's worth fixing promptly rather than waiting.

Low or no water

Check the breaker for the pump first. If it's on and the house is dry, the switch, the pump or the wiring may have failed. In deep cold, the line between the wellhead and the house, or the pressure tank itself, may have frozen.

Changes in the water

Cloudy water, sand in aerators or a new taste or smell can point to a problem in the well or with a filter. Have private well water tested regularly, and note when any change started so the plumber or well specialist can trace it.

Protect it from the cold

The pressure tank, switch and nearby piping must stay above freezing. Insulate the well house or pump room, check any heat source before winter and seal drafts where the line enters the house.

Getting help

Tell the plumber what you hear, what the pressure gauge reads and whether the breaker has tripped. Send a request and a plumber will get in touch.